-40%
Hurst Indy Chrome Stick Shifter Rubber Floor Boot & Trim Plate Kit
$ 6.29
- Description
- Size Guide
Description
Hurst Indy rubber floor bootw/ trim ring; a "universal" cover for shift lever opening in floorpan; not specific to any application but dependent upon size of floor opening
Genuine Hurst part
as found in retail # 1148429 but bulk part, no retail pkg
Also sold as Mr Gasket # 9648
Plain rubber boot
(no logo) w/ chrome-plated steel trim ring
Same size as Hurst B-4 but without logo
Mounting screws NOT included; #8 recommended
Fits Hurst chrome FLAT sticks
Stick opening is rectangular ~ 3/8" wide x 3/4" long
NOT for use with ROUND sticks!
5.35" wide x 6.5" long overall,
for floor openings up to 3.5" wide x 4.5" long
Mounting hole pattern = 4.25" wide x 5.32" long
Drilling required; use a #29 drill bit for #8 screws
Refer to second image for installation instructions
Measure & study floor opening before you buy!
Shifters with long travel in boot area or floorpans with high curvature may require larger boot to avoid tear-out
Consider the larger SuperBoot for floor openings up to 6" wide x 7" long (
especially trucks
)
Rubber boot also available alone (without trim) if you just need to replace the boot. This is the same boot used in the 1983-1993 Mustang Hurst console trim plate kits.
We also offer the Indy Qualifer (1" smaller each way ), Hurst B-4 (same size but w/ H logo), and larger SuperBoot